To continue?", click on the "Yes" button. We really are not on the same layer anymore, so where it says "Do you want ", but remember, weĬhanged from the top layer of the board to the bottom layer of the board, so You will get a warning message that says "Warning: you are attempting toįlip a component to the same side of the board. Hit "x" on your keyboard to flip the array. The Paste Special Dialogue for "Paste on current layer", "Keep net name",Īnd "Duplicate designator", and then click on the "Paste" button. Use E A (Edit Paste Special) to copy the array, and "check off" the boxes in Use E C (Edit Copy) and click on your reference point to set the reference Select everything on the top layer (including all traces and components, Turn off all layers except the top layer. The lower right of the new board location.on this grid. Reference point at the lower left of the original board, and another one at It will be much easier to do this if you set your grid to. Make sure you have a large area to the right or above you original board to Try this with a copy of your database, so that you do not loose anything if What was on the bottom then becomes flipped to the top. The components and circuitry on the top and flip it on the bottom, and that I am not quite sure what you are asking here, but I think you want to take
On this forum titled "Flipping Board" dealing with this problem.Īs the access to the old archives may not be easy, below I copy Once upon a time - precisely in October 2002, there was a thread Messages sorted by: Īs others have already stated - it's not a simple operation.Next message: Protel 99SE - Moving a selection to the other side of the of the board.Previous message: Protel 99SE - Moving a selection to the other side of theboard.Protel 99SE - Moving a selection to the other side of the board.